RECO
To connect RECO to NeoLAB Cloud
Last updated
To connect RECO to NeoLAB Cloud
Last updated
To connect RECO to NeoLAB Cloud, you need to directly connect its built-in 5-pin USB to your PC.
Since the data size of RECO is larger than that of the smartpen, you can selectively upload data by activating the [Data Upload] button.
Only one RECO can be connected to the cloud at a time.
If you change the RECO device name, the cloud may not recognize it, so please keep the name of the RECO storage as [NPR-R100].
Since RECO cannot measure battery, it remains in the [Charging] state when connected.
Connect your PC and RECO with a 5-pin data transfer cable.
Run the NeoLAB Cloud.
If 'RECO' appears in the connected devices, please press the [Upload Data] button to upload your handwriting and audio data.
Run the NeoLAB Cloud.
Connect your PC and RECO with a 5-pin data transfer cable.
If a permission popup appears, please click [Allow].
In Finder, select [NPR-R100] and then click [OK].
If you click the [Cancel] button on the permission popup, the RECO will be connected but the permission message will continue to be displayed.
When you click on the "You need permission to use RECO." message, please click on the [NPR-R100] folder of RECO, and then press the [OK] button.
When you click the [OK] button, you can see that RECO is successfully connected to the cloud as shown above.
If there is data in the RECO device, the [Upload Data] button will be activated.
Click the [Upload Data] button to upload the data if you want.
You can view the RECO data in Neostudio.
